THIS LISTING IS FOR EVERYTHING PICTURED! Set of Inner Cam Bearing Puller and Installation Tools Designed for Twin Cam and Dyna models. Will work on all TC88, 96, 103 and 110s that use the B148 or the B168 bearings. This set will remove and install the inner cam bearings on both newer and older model Twin Cams and Dyna Harleys. We also have new Torrington-Koyo B-148 and B-168 bearings available in our store under the Harley Davidson section! This set includes our Improved collet design. The design sold by others has the whole back of the collet threaded with two slots cut into the threads for turning a wrench on. It's simple, it's cheap, and it's bad. Use that design once or twice, and you may damage the threads where the wrench makes contact, requiring you to now clean up those threads before you can even get the nut off the collet and use it again. We've worked around this issue by moving the threads up on the collet to allow for a more controlled grip and protection of threads. We've also completely redesigned the installer plate, zeroing in on the correct hole placement by taking apart an engine and putting it on a digital drafting table to get the precise placement of all of the important dimensions. This set also includes our Patent Pending window modification to the installer plate. You paid too much for the bike and the tools to end up cracking the engine case because you can't see the bearing! With the redesign, you will never again have to squint through a tiny hole with a flash light!