Flywheel Puller Guide By Size

Grade 8 High-Strength Steel Hex Head Screw Bolt Flywheel Puller

Good for demanding applications such as suspension system, these screws are at least 25 % stronger than medium-strength steel screws. Length is measured under the head. Zinc yellow- chromate plated...

Flywheel Puller Male 28 mm x 1.25 mm Right Hand 2 Piece

This listing is for a new Flywheel Puller Male 28 mm x 1.25 mm, Right Hand Threads. Compatible with Harley Davidson 50/65CC Aermacchi motor which was used from 65 thru 72 on two models, Leggero and...

RIGHT Hand Thread 27mm x 1mm Puller Compatible for Gas Trial MZB Ignition Flywheel Rotor Magneto

This listing is for a new Flywheel Puller 27mm x 1.0mm.The following is for reference only. Please check the thread size of your motor before ordering. This is used for less common applications, make...

Clutch Puller, Primary Drive 14mm ATV UTV Compatible for Kawasaki , Arctic Cat like 57001-1404

This listing is for a new 14mm Primary Drive Clutch Puller.Designed to remove the Primary Clutch. Compatible with

Flywheel Puller 7 Hole Disc 6mm Bolts Mini 50 MX Mini Racer Senior European

7 Hole Flywheel Puller Disc with 6mm Bolts. Compatible with KTM 50MX Mini Racer and 50MX Senior. This puller is professionally mad

Single Wide Case Flywheel Puller [62mm x 1mm] Compatible for Ducati

This listing is for a new Flywheel Puller 62mm x 1mm with Right Hand Threads.Note: The following is for reference only. Please check the thread size of your motor before ordering. 

Flywheel Puller [55mm x 1mm] Compatible for Ducati Single 250 NC

This listing is for a new Flywheel Puller 55mm x 1mm Right Hand Threads.

Flywheel Puller [38mm x 1.5mm] Compatible for Kawasaki Suzuki KLX400

This listing is for a new Flywheel Puller 38mm x 1.5mm Right Hand Threads.Note: The following is for reference only. Please check the thread size of your motor before ordering. 

Flywheel Puller [35mm x 1.5mm] Compatible for Honda Yamaha 350 Warrior

This listing is for a new Flywheel Puller 35 mm x 1.5 mm Right Hand Threads. Note: The following is for reference only. Please check the thread size of your motor before ordering.   

ATV Flywheel Puller CH250 Elite 33mm x 1.5mm Compatible for Suzuki GSXR600 & GSXR750

This listing is for a new Flywheel Puller 33mm x 1.5mm Right Hand Thread. Threads are outside of the engine part (Inside female threads on tool). Note: The following is for reference only. Please c

Flywheel Puller [33mm x 1.5mm] Compatible for Bultaco Ossa Husqvarna

This listing is for a new Flywheel Puller 33 mm x 1.5 mm Right Hand Threads.Note: the following is for reference only. Please check the thread size of your motor before ordering.

Flywheel Puller [30mm x 1.5mm] Compatible for Kawasaki Suzuki GS

This listing is for a new Flywheel Puller 30mm x 1.5mm Right Hand Thread.Note: The following is for reference only. Please check the thread size of your motor before ordering.